No-dig pipe repair on the Lower North Shore.
Cracked or root-damaged pipe repaired in place in Hornsby Heights — a new liner cured inside the old pipe, so an established garden never has to come up.
No callout fee on eligible jobs · Free quotes
Hornsby Heights is 97.9% separate houses on an elevated plateau backing directly onto Berowra Valley bushland. Mature native roots sit against private drainage on the outer blocks, and the runs coming off the plateau are long — so the fault is routinely a considerable distance below the house, and a trench deepens all the way to it.
Root masses from Berowra Valley bushland in private pipe, typically a long way down a run coming off the plateau. At 97.9% detached there is essentially never a shared line.
Because putting the garden back costs more than fixing the pipe. This is the part of a drainage repair people do not price until an excavator is already on site.
Established gardens on plateau blocks with Berowra Valley bushland beyond. With almost no unit stock, every reinstatement sits with one owner.
A liner goes in through an opening that already exists. Nothing above the pipe has to move.
An elevated plateau above the Berowra Valley, with long falls from the house to the connection on most blocks.
Hornsby Heights sits in the Hornsby Shire, postcode 2077.
Local figures sourced from: ABS 2021 Census QuickStats — Hornsby Heights
Drainage of a broadly consistent generation across the plateau, rather than the century-spanning mixture found further south.
No trench, no spoil, and nothing above the pipe disturbed. The whole job runs through an existing access point.
The line is inspected end to end so the damage is located and measured. Nothing is quoted from the surface.
Roots are cut out and the pipe wall is jetted back to bare material — a liner will not bond to a coated pipe.
A resin-saturated liner is drawn into position through an existing access point and inflated against the host pipe.
The resin hardens in hours rather than days, forming a new pipe inside the old one with no joints for roots to re-enter.
Any branch lines are cut back open robotically, and a final camera pass confirms the result.
Not every damaged pipe should be relined, and we will say so. These are the cases where it genuinely wins here.
Trench depth and cost climb together.
Root entry recurs unless the joint is sealed.
One owner carries the whole decision.
Relining costs more per metre than excavation. It is usually cheaper overall, and this is why:
| Dig and replace | Relining | |
|---|---|---|
| Excavation | Trench the full length, remove and replace the pipe, backfill | None — the work runs through an existing access point |
| What comes up | Lawn, garden, paving, driveway or slab above the line | Nothing |
| Time on site | Days on a long or deep run | Usually one day for a typical run |
| Reinstatement | Priced separately and often the larger half of the bill | Not applicable |
| Result | New pipe, with joints | A jointless liner inside the host pipe |
| Design life | Depends on material and bedding | 50 years on a correctly installed liner |
The per-metre comparison is the one that misleads. Excavation quotes routinely exclude spoil removal and reinstatement, which is where a dig job gets expensive — and on some properties the reinstatement is simply not possible at any price.
These are typical ranges across the Sydney market — not Voyager’s price list, but a realistic yardstick to judge any quote against, including ours.
| Pipe relining, per lineal metre | $450 – $800 |
| Pipe relining, typical whole job | $4,000 – $10,000 |
| Patch repair, single damaged section | $1,500 – $3,000 |
| Junction reinstatement | $300 – $600 |
| Excavate and replace, per metre | $300 – $600 |
| Driveway reinstatement after a dig job, per sqm | $100 – $200 |
| CCTV drain inspection | $250 – $550 |
| Cutting tree roots from a line | $400 – $1,200 |
Voyager prices by the job, not by the hour, so the number you approve is the number you pay. A camera survey happens before any figure is given — a quote for relining that has not looked down the pipe is a guess.
Most Hornsby Heights properties that ring about relining need a camera first. We will tell you straight — including when clearing the line is the whole job.
A correctly installed liner carries a 50-year design life, and it cures in hours rather than days — so the property is back in normal use the same week rather than the same month.
Sealing the joint converts an annual clear into a repair on a run where every visit means crossing the same garden.
Roots come back through joints. A liner has none.
Voyager covers the whole Lower North Shore. These are the closest to Hornsby Heights:
No. That is the whole point of it. The liner is drawn in through an existing access point — usually an inspection opening or shaft already on the property — and cured in place against the old pipe. It means an established garden on a plateau block is not opened and no spoil is carried back across it.
Across the Sydney market, relining runs about $450–$800 per lineal metre, with a typical whole job landing between $4,000 and $10,000 and a single-section patch around $1,500–$3,000. Those are market ranges rather than Voyager’s price list. Run length off the plateau and reinstatement at the far end of it, carried entirely by one owner.
Per metre, no — excavation is cheaper per metre. Overall it usually is. The dig figure rarely includes putting the garden back, and on established planting that is routinely the larger half of the job. On some properties the reinstatement is not possible at any price, which settles it entirely.
A correctly installed liner carries a 50-year design life. It outlasts what it replaced because it has no joints along its length — and joints are where roots get in, where ground movement opens a gap, and where old earthenware fails first. Which means the garden above it is not being opened again in ten years.
A typical residential run is a single day on site, and the resin cures in hours rather than days. The camera survey happens first, either on the same visit or beforehand — nothing about a relining job should be quoted from the surface.
Most can, but not all — and we will say so rather than sell you something that will not work. A pipe that has collapsed completely, or lost so much of its shape that there is nothing left to line against, needs replacing. In Hornsby Heights the host pipe is usually a good candidate: root masses from Berowra Valley bushland in private pipe, typically a long way down a run coming off the plateau. At 97.9% detached there is essentially never a shared line.
Not at all. Hornsby is 59.1% apartments with shared stacks and commercial load; Hornsby Heights is 97.9% separate houses on a plateau backing onto Berowra Valley bushland, where the job is a long private run under an established garden. Neighbouring suburbs, opposite problems, opposite arguments for relining.
Through that section, yes. Roots enter at joints and cracks; a liner is continuous and seals them, so the entry point is gone. Roots can still find a different fault further along an old line, which is why the survey covers the whole run rather than only the section that failed.
Camera survey first, a fixed price agreed before the work starts, and no excavation.
Voyager Plumbing · NSW Contractor Licence 476657C
Verify with NSW Fair Trading
Page reviewed and updated 20 August 2026
